Printed Parts
The printed parts are presented in the videos contained in this playlist.
The parts were made to be printed easily and without any supports but need to be oriented individually. There are two print settings to consider:
- 0.2-0.3 layer height, 4x 0.4mm perimeters, 20% infill - PETG
- 0.1 layer height, 4x 0.4mm perimeters, 20% infill - PETG or something more heat resistant for the layer fan ducts.
| Part | Link |
|---|---|
| bottom_mgn15_short_duct | GitHub |
| Duct v2 Straight Risen | GitHub |
| back_corexy_90deg | GitHub |
| tension_slider_9mm_belt_M5_mirror | GitHub |
| tension_slider_9mm_belt_M5 | GitHub |
| cable_side | GitHub |
| unversal_cable_mount | GitHub |
| top_mgn15_raw | GitHub |
| face_v6 | GitHub |
| face_v6_40mm_fan | GitHub |
| face_mosquito | GitHub |
| mosquito_front | GitHub |
| back_cartesian | GitHub |
| tension_slider_6mm_belt_M3 | GitHub |
| cartesian_cable_fin | GitHub |
| bottom_mgn12_short_duct | GitHub |
| top_mgn12_raw | GitHub |
| face_titan | GitHub |
| face_mosquito_titan | GitHub |
| top_mgn15_bmg | GitHub |
| top_mgn12_bmg | GitHub |
| bottom_mgn15_long_duct | GitHub |
| face_aero | GitHub |
| face_aero_support | GitHub |
| bottom_mgn12_long_duct | GitHub |
| Duct v2 Angled 20deg Risen | GitHub |
| face_hemera | GitHub |
| face_hemera_front | GitHub |
| Duct v2 Volcano Straight Risen | GitHub |
| Duct v2 Volcano Angled Risen | GitHub |
| Back IDEX X1 | GitHub |
| Back IDEX X2 | GitHub |